A batten board is nothing more than a 1 x4 or 1 x2 board screwed directly into the wall horizontally.
Setting large wall tiles.
With traditional tile that is less than 15 x 15 there can be up to a 1 4 variance in the substrate over a 10 span.
So if the tiles are 10 inches high the line should be 10 25 inches off the floor.
Where a recess is more than one tile deep have a complete tile on the front edge.
Videos you watch may be added to the tv s watch history and influence tv recommendations.
To avoid this cancel and sign in to.
For tile with at least one edge greater than 15 the american national standards institutes ansi recommends a maximum variance of 1 8 over a 10 span and 1 16 over a 24 span.
Instead bring it up to about 3 4 of the height of your tiles.
If playback doesn t begin shortly try restarting your device.
Keep the tiles in a.
Mark a horizontal line along the bottom of the wall coming up from the floor by the height of your tile plus one quarter inch.
So if you re dealing with four inch tiles your batten board would start three inches off the floor.
Try to achieve a full tile height above the side of a bath worktop.